Articulated & flexi 3D print models
(24)Print flat in one piece, lift, and it moves: snakes, octopuses, a crayfish, a reptile cosplay mask with moving jaw, a flexible TPU wristband. The print-in-place 3D print designs filed outside the dedicated category, including the articulated animals listed elsewhere.
They are FDM models in PLA or TPU, printed at 0.16 to 0.2 mm with a slight flow reduction; check the creator's settings and size on the model page. The most popular design has its own page, articulated dragons; the snakes and octopus pages hold the other flexi animals alongside their resin cousins.
24 models
Frequently asked questions
The joints fused: lower the flow by a few percent, reduce initial layer squish, and flex each joint gently as soon as the print comes off the bed.
Rarely well. Standard resin is too brittle for hinges; only designs tested by their creator in flexible resin work.
Small ones, the crayfish or a short snake, in under two hours at 0.2 mm. Larger articulated animals take an afternoon but need no supports or cleanup.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























