Snakes & serpents 3D print models
(15)Snakes are a favourite for two opposite reasons: realistic reptiles 3D print beautifully in resin, and articulated snakes are one of the most satisfying print-in-place models for filament. Both are here: a king cobra, a hognose, a rock python and a sea serpent on one side; flexi articulated snakes on the other; plus serpent-folk miniatures for tabletop and a snake-shaped phone stand.
Realistic snakes have no thin parts to break, only scale texture that needs a 0.05 mm layer height to show. Coiled sculpts print in one piece at 10 to 15 cm; hollow them if they are thick. Articulated snakes link each segment to the next with a hinge and print flat on an FDM bed with no supports, then flex once removed.
The model page states the intended process and material. More print-in-place animals are in articulated and flexi, and the other cold-blooded models in dinosaurs.
15 models
Frequently asked questions
The joint clearance is too small for your printer. Print at 0.16 to 0.2 mm layers, lower the flow by a few percent, and avoid a brim between segments. The creator's model page usually lists the tested clearance.
A base colour, a thin dark wash in the recesses, then a light dry-brush across the scales. Realistic snake sculpts have enough relief that this three-step method looks finished.
A coiled python or cobra on a base. The coil supports itself, there are no thin parts, and the scales tell you immediately whether exposure and layer height are right.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.














