Articulated dragons 3D print models
(5)The signature print of filament 3D printing: a chain of linked segments that prints flat in one piece, with no supports, and moves like a snake once lifted from the bed. The line includes a numbered series, crystallised versions, a keychain-size dragon and designs with wings or spikes.
They are designed for FDM in PLA, printed at 0.16 to 0.2 mm with a slightly reduced flow so the joints stay free; a 20 to 30 cm dragon prints in four to eight hours, belly on the bed. In resin, articulated dragons do print, but the joints need a tough or flexible resin and careful support removal; the model page says whether the creator tested a resin version. Multi-colour printers make the crystal versions shine.
The non-articulated dragons, sculpted for resin, are in dragons; the other print-in-place animals in articulated and flexi, and the small ones in keychains.
5 models
Frequently asked questions
Over-extrusion or too fine a layer height closed the clearance. Lower the flow by 2 to 5 %, print at 0.2 mm, avoid elephant foot with a slight initial layer squish reduction, and flex each joint gently right off the bed.
Only with a tough or flexible resin and a design made for it; standard resin cracks at the joints. Check the model page for a resin-tested version.
Four to eight hours for a 20 to 30 cm dragon at 0.2 mm on a typical FDM printer, with no supports and no post-processing beyond flexing the joints.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.




