Swords & blades 3D print models
(33)Two sizes of blade share this page: weapons for 32 mm miniatures, sold as bits packs or attached to figures, and prop-size replicas for display and cosplay. A legendary sword in the stone, a cyberpunk katana with its sheath, goblin sword packs and a sword from a well-known video game are among the 3D print files here.
Miniature blades print in resin and are the part most likely to break on a figure, so supports matter; print at 0.05 mm in a tough resin. Prop-size swords are a different craft: cut into sections of 15 to 25 cm, printed in PLA or PETG with a rod running through the pieces, then sanded, filled and painted.
If you print props, check your local rules on replica weapons before carrying one to an event. Body armour and chainmail for the same costume are in armor, the helmets in helmets.
Most miniature weapon packs are scaled for 28 to 32 mm figures; check the creator's scale before mixing bits across lines.
33 models
Frequently asked questions
Use the creator's split version, or cut the blade into 15 to 20 cm sections in Lychee Slicer with a pin hole through each, print them standing or at 45 degrees, and glue them over a fibreglass or aluminium rod.
Standard resin is brittle at 1 mm thickness. Print weapons in a tough or ABS-like resin, keep supports along the blade and remove them before final curing.
Dark grey base, silver dry-brushed along the edge, a black wash in the fuller, and a final line of bright silver on the very edge. For a prop, use a silver spray over a gloss black primer.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























