In: Models

    Helmets 3D print models

    (3)

    A cyber skull helmet, an oni stormtrooper and a samurai stormtrooper mash-up, plus the helmets attached to character busts: display and cosplay helmets beyond the dedicated Masks & Helmets category.

    Wearable helmets are FDM 3D print projects in PLA or PETG, split into parts and finished with sanding and primer; display helmets print in resin at 10 to 15 cm. The model page states the intended size and cuts. Faces rather than full heads are in masks, the galactic originals in Star Wars, and the body pieces in armor.

    3 models

    Samurai Stormtrooper Helmet  - 3D printable Masks
    Samurai Stormtrooper Helmet
    ‌
    ‌
    Oni Stormtrooper Helmet - 3D printable Masks
    Oni Stormtrooper Helmet
    ‌
    ‌
    Cyber Skull Helmet - 3D printable Masks
    Cyber Skull Helmet
    ‌
    ‌

    Frequently asked questions

    If the creator split it into parts that fit 20 cm cubes, yes; the model page says so. Otherwise scale it down for display.

    Sand to 400 grit, two coats of filler primer, sand again, then paint and a clear coat. Add foam padding inside for wear.

    Glue foam blocks inside at the forehead, temples and crown, and cut a visor from a tinted PETG sheet heated and bent to the opening. Both are standard cosplay supplies.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.