Samurai & ninja 3D print models
(22)Samurai, ninja, oni masks and demons from Japanese folklore: a lady techno samurai, a foot ninja, oni half-masks and a samurai stormtrooper helmet, mostly resin 3D print miniatures and busts, with a few wearable masks for FDM.
Layered armour and masks print cleanly in resin; keep supports on blades and helmet crests. Oni demons sit between this theme and demons, wearable versions in masks, and the katanas themselves in swords.
A katana prints best upright or at a steep angle in a tough resin, then cures lying flat on glass.
22 models
Frequently asked questions
Some are sculpted at face size for FDM or large resin printers; others are display pieces. The model page states the intended size and whether the mask is split into parts.
Print it upright or at a steep angle with supports along the spine, in a tough resin, and cure it lying flat on a clean glass surface.
Black or deep red base, a gloss varnish on the plates, then a matte varnish on the cords and fabric between them. The contrast between gloss and matte is what reads as lacquer.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.





















