Demons & devils 3D print models
(40)Demon lords, succubi, imps, devils and a whole line of demon witches, from 32 mm encounter miniatures to 15 cm display sculpts. Horns, wings and tails are their signature and their 3D printing challenge.
Resin is the process for these; keep supports on wing membranes and horn tips, and hollow the large pieces. Demon witch and succubus lines are published as series, with matching bases and poses for a coherent coven. The hunters are in KPop Demon Hunters, the Japanese oni in samurai and ninja.
40 models
Frequently asked questions
Keep the creator's supports under the membranes, tilt the model so the wings are not parallel to the plate, and print at 0.05 mm. Thin membranes need a tough resin to survive handling.
Fifty to one hundred millimetres at 28 mm scale, depending on wingspan. The model page states the creator's intended base.
Deep red base, a black-brown wash in the muscle lines, then an orange highlight on the ridges. Horns in bone or black with a gloss varnish set the face off.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























