Keychains 3D print models
(29)Fast, cheap, easy to give away, and a good excuse to test a new resin: keychains are the small 3D print everyone ends up making. The line here is strong on superhero and movie characters, Venom, Deadpool, Wolverine, Dr Doom, the Fantastic Four, Dracula and Frankenstein, with pumpkins, a steampunk charm, an astronaut and a crystallised articulated dragon alongside, plus a few hooks to hang them on.
Most are sculpted at 4 to 6 cm with a built-in loop, and the loop is the detail to check before printing: at least 2 mm thick to survive a pocket, and oriented so supports do not touch it. In resin, a tough or ABS-like resin is the right choice; standard resin keychains crack within weeks. In FDM, PETG beats PLA for the same reason.
At this size an MSLA printer fits twenty keychains in a single two-hour job, which makes them ideal gifts and event giveaways. The same loop and material rules apply to earrings and pendants, and most ornaments are keychains with a bigger loop.
29 models
Frequently asked questions
In resin, a tough or ABS-like resin, fully cured. In filament, PETG or nylon. Standard resin and PLA both break at the loop after a few weeks of pocket wear.
Most loops accept a 20 to 25 mm split ring. The model page usually gives the hole diameter; if it does not, measure it in Lychee Slicer before buying rings.
Lay them flat or tilt them 15 degrees, supports on the back face only, and fill the plate in your slicer's arrange view. Print at 0.05 mm; a full plate takes about two hours on most MSLA printers.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























