Ornaments 3D print models
(18)Hanging ornaments are the easiest 3D print to give away and the one that shows off coloured resins best: a Christmas beholder, a goblin bauble, a D20 bauble, presents with a gift box, Christmas tree earrings, Studio Ghibli ornaments and a set of hearts for other occasions. Most are designed with a loop or an eyelet and a hollow body.
Print them in resin at 5 to 8 cm with the loop at the top, supported lightly on the back; a translucent or glitter resin makes them look finished without paint. Baubles with a closed sphere must be hollowed with a drain hole, which the creator usually includes. On FDM, print the sphere in two halves or use a design with a flat base.
A plate of eight ornaments prints in about two hours. The seasonal pages, Christmas, Halloween and Easter, hold the rest of the decorations.
Thin loops benefit from a tough resin: the loop is the part that fails when an ornament is hung and unhung every year.
18 models
Frequently asked questions
Trapped resin inside a closed sphere expands under UV. Make sure the model has a drain hole, drain and rinse the inside before curing, and cure in short passes rather than one long one.
Most loops take a standard ornament hook or a 1 to 2 mm ribbon. The model page gives the loop diameter; thin loops benefit from a tough resin.
Eight to twelve at 6 to 8 cm on a mid-size MSLA printer, in about two hours, plus washing and curing. Two plates after dinner decorate a tree.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.

















