Skulls 3D print models
(48)Skulls are everywhere in 3D printing: on tabletop bases, as Halloween decor, as pen holders and as pure display anatomy. The ones here run from an ornate carved skull and a skull with a crown to pop culture variants such as a Mewtwo skull, plus packs of small skulls to scatter on miniature bases.
A skull is also one of the most rewarding prints for a resin beginner. The shape has few overhangs, hollows cleanly and prints well at 0.05 mm layers; the eye sockets and teeth show whether your exposure settings are right. Larger decorative skulls print at 10 to 15 cm and take paint or a dry-brush very well; base-size skulls print by the dozen on a single plate.
Full skeletons and bone warriors have their own page in skeletons, and most of these skulls reappear in Halloween decor.
Hollowing a skull above 10 cm with a 2 mm wall and two drain holes at the base saves most of the resin and avoids the suction failures that plague big single-piece prints.
48 models
Frequently asked questions
Yes, especially decorative skulls above 8 cm. Print them with the base of the skull on the bed, supports under the jaw and cheekbones, and a 0.12 mm layer height. For tabletop base skulls, resin is better: filament cannot render teeth at 5 mm.
In Lychee Slicer, use Hollow with a 2 mm wall and place two drain holes at the bottom of the skull. Printing it hollow saves most of the resin and reduces suction, which is the main cause of failures on big single-piece models.
Ivory or bone-white base, a brown wash over everything, then a dry-brush of off-white on the ridges. Three steps, ten minutes, and it reads as bone even on a large piece.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























