Skeletons 3D print models
(35)Skeletons are the workhorses of fantasy wargaming: cheap to field, easy to paint, endlessly reusable. The skeleton warriors, archers, rising undead and spearmen here are mostly 32 mm resin 3D print miniatures published in sets of several poses.
Thin bones are what make them tricky to print. Support every limb that leaves the body and print at 0.05 mm; a plate of ten skeletons takes under three hours on most MSLA machines. Zombies and liches are on the undead page, and bare skulls in skulls.
35 models
Frequently asked questions
Because the bones are a millimetre thick. Remove supports under warm water after washing and before curing, when the resin is still slightly flexible, and cut rather than snap them off.
A tough or ABS-like resin, or a standard resin blended with 20 to 30 % flexible resin. Pure standard resin is too brittle for thin bones.
Spray bone white, apply a brown contrast wash, dry-brush ivory. Pick out weapons in metal and shields in one colour. Twenty minutes per batch, not per figure.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























