In: Models

    Sharks 3D print models

    (6)

    A realistic shark, a zombie shark, a shark-bear hybrid, cartoon versions and a few crossover characters: resin 3D print figures at 8 to 15 cm with a stand or a wave base.

    Fins are the thin parts; print at 0.05 mm, hollow anything above 10 cm, and use grey resin for a quick finish. Cartoon sharks are among the easiest resin prints for beginners. The rest of the ocean is in octopus and kraken, fish and mermaids.

    A 12 cm shark hollowed with a 2 mm wall prints in about three hours.

    6 models

    Zombie Shark - 3D printable Creatures
    Zombie Shark
    ‌
    ‌
    Sharkii - 3D printable Art Toys
    Sharkii
    ‌
    ‌
    Sharkenbear - 3D printable Creatures
    Sharkenbear
    ‌
    ‌
    Shark - 3D printable Characters
    Shark
    ‌
    ‌
    SharkoGuile - 3D printable Creatures
    SharkoGuile
    ‌
    ‌
    Celine's Sharktooth Necklace - 3D printable Characters
    Celine's Sharktooth Necklace
    ‌
    ‌

    Frequently asked questions

    Most sculpts include a wave or rock base; if not, print a small stand from the Bases theme and pin the belly to it after curing.

    Yes at 15 cm or more, lying on its side with supports under the fins. Detail will be softer than in resin.

    Blue-grey on top, white underneath, blended along the flank with a dry brush, then a dark wash in the gill lines and a gloss varnish for the wet look.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.