Wolves 3D print models
(22)Dire wolves, lunar wolves, armoured wolves, Fenrir and a few wolfmen: close to two dozen 3D print sculpts for tabletop encounters and display. Fur and bared teeth are what resin shows best at 32 mm.
Keep supports under the muzzle and legs, print a pack on one plate in grey resin, and hollow the wolfmen and armoured wolves above 8 cm. The transformed cousins are in werewolves, the Norse ones in vikings, and the smaller canids in foxes.
22 models
Frequently asked questions
32 to 40 mm rounds at 28 mm scale; common wolves fit 25 mm. The model page states the creator's intended base.
Grey resin, a dark wash, then a white dry-brush along the back and muzzle. Three steps, five minutes a figure.
Fenrir or the armoured wolf scaled to 75 mm, hollowed. The fur texture holds up at that size and takes a grey dry-brush in minutes.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.





















