In: Models

    Vases 3D print models

    (8)

    The classic FDM showcase: a dragon vase, a crystal vase, spline curves, a belly vase and plain forms designed for vase mode, where the printer draws a single continuous wall. This page adds the sculpted vases meant for resin to the Vases category.

    Check whether the creator designed a piece for spiral vase mode or as a solid sculpt, and 3D print in PLA or PETG; resin vases should be sealed inside before holding water. Pots for living plants are in planters, flowers to fill them in flowers, and the dragon vase also sits in dragons.

    8 models

    Dragon Vase - 3D printable Vases
    Dragon Vase
    ‌
    ‌
    Vases - 3D printable Miniatures & Tabletop
    Vases
    ‌
    ‌
    Curve Spline Vase - 3D printable Home Decoration
    Curve Spline Vase
    ‌
    ‌
    Fire flame vase - 3D printable Home Decoration
    Fire flame vase
    ‌
    ‌
    Flame vase - 3D printable Home Decoration
    Flame vase
    ‌
    ‌
    Crystal Vase - 3D printable Home Decoration
    Crystal Vase
    ‌
    ‌
    Heart Vase - 3D printable Vases
    Heart Vase
    ‌
    ‌
    Belly Vase - 3D printable Home Decoration
    Belly Vase
    ‌
    ‌

    Frequently asked questions

    Vase-mode prints in PETG with a 0.6 mm or wider wall usually hold water; PLA can seep. For resin vases, coat the inside with a clear sealant or use them for dry arrangements.

    A slicer setting that prints the outer wall as one continuous spiral with no infill or seams. Vases designed for it have a single wall and a flat bottom.

    0.6 to 1 mm, set by the nozzle and line width. A 0.6 mm nozzle gives a sturdier vase; a 0.4 mm nozzle with 0.6 mm line width is the usual compromise.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.