Vampires 3D print models
(30)Dracula, Nosferatu, vampire lords and ladies, feral spawn and the coffins to go with them: about twenty 3D print figures for gothic tabletop games and display. Capes, lace and gaunt faces are what resin shows best.
Print at 0.05 mm with supports along cape edges, and paint pale skin over a dark base for the classic look. A vampire lady with her human form and coffin makes a complete campaign NPC set from a single creator. Their rivals and minions are in werewolves and undead.
30 models
Frequently asked questions
A cold grey or lilac base, a thin flesh glaze, then a dark wash in the eye sockets and mouth. Keep the cape in deep red or black for contrast.
Usually, and some open. The model page says whether the lid is a separate part; print it flat for a clean surface.
Dracula or a vampire lord scaled to 75 mm, hollowed, with the cape printed in a dark red resin and the skin painted pale. The coffin from the same creator makes a base.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























