In: Models

    Trees & plants 3D print models

    (15)

    Dead trees, cursed trees, evergreens, a tree of life, a tree with an owl, a Totoro treehouse and a Christmas tree or two: trees and plants for terrain and for decoration, from 28 mm scenery to shelf pieces.

    Branches are the 3D printing challenge: print at 0.05 mm in resin with supports along each branch, or choose the chunkier stylised trees for FDM. Terrain trees sit with the bases, and the potted side of the garden in planters and flowers.

    15 models

    Dead Trees - 3D printable Miniatures & Tabletop
    Dead Trees
    ‌
    ‌
    My Neighbor Totoro Treehouse Diorama - 3D printable Anime & Manga
    My Neighbor Totoro Treehouse Diorama
    ‌
    ‌
    Treecko - 3D printable Anime & Manga
    Treecko
    ‌
    ‌
    Totoro Treehouse flower pot - organizer - 3D printable Anime & Manga
    Totoro Treehouse flower pot - organizer
    ‌
    ‌
    Corrupted dead trees  - 3D printable Fantasy
    Corrupted dead trees
    ‌
    ‌
    Tree with Ravens - 3D printable Characters
    Tree with Ravens
    ‌
    ‌
    Lair Entrance Gnarled Tree - 3D printable Characters
    Lair Entrance Gnarled Tree
    ‌
    ‌
    Leafy Tree - 3D printable Characters
    Leafy Tree
    ‌
    ‌
    Cursed Trees - 3D printable Characters
    Cursed Trees
    ‌
    ‌
    Tree with Flying Owl - 3D printable Characters
    Tree with Flying Owl
    ‌
    ‌
    Evergreen Tree - 3D printable Characters
    Evergreen Tree
    ‌
    ‌
    The Dark Tree - 3D printable Creatures
    The Dark Tree
    ‌
    ‌
    Christmas Tree earrings/ornament - 3D printable Props
    Christmas Tree earrings/ornament
    ‌
    ‌
    Christmas tree - 3D printable Home Decoration
    Christmas tree
    ‌
    ‌
    Cheese Christmas Tree - 3D printable Home & Household
    Cheese Christmas Tree
    ‌
    ‌

    Frequently asked questions

    The dead, cursed and evergreen trees sculpted on 40 to 60 mm bases, sized for 28 mm games. Print several and vary the scale by 10 % for a natural forest.

    Use a tough resin, keep supports along each branch and remove them before curing. For FDM, pick stylised trees with thick branches.

    Dark brown base, a black wash, then a dry-brush of grey-brown on the bark ridges. A touch of green at the base for moss ties it to the table.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.