Tanks 3D print models
(24)Mostly historical wargaming at 28 mm: French Army vehicles of 1940 such as the B1 bis, the AMX 40 prototype or the Renault D1 and D2 with their pilots, German Panzers from the Ausf. A to the Maus, often published with crew figures, plus a few fantasy and post-apocalyptic machines like a goblin tank or wasteland war machines. All 3D print models by independent creators.
Printing a tank is a different exercise from printing a figure. Tracks, hull and turret are large flat volumes that print well hollowed, while gun barrels, aerials and tow hooks are the fragile parts. Many creators cut their vehicles into hull, turret and track sections that assemble with a pin, so each part fits a standard resin build plate and the turret can rotate.
Keep the hull flat to the plate or tilted by a few degrees, and print the barrel upright if it is a separate part. Infantry at the same scale is in the miniatures lines, and other vehicles in cars.
24 models
Frequently asked questions
Most are 1:56, the usual 28 mm wargaming scale, to match infantry from the same creators. Some are published at 1:100 or 1:72 for other systems; the model page says which. You can rescale in Lychee Slicer, but check that barrels and tracks stay thick enough to print.
Resin gives you rivets, track links and hatch detail at 1:56. FDM works for the hull of larger scales, 1:48 and up, especially if you print the fine parts separately in resin. Several creators publish both versions; check the model page.
Base colour sprayed, then the second colour brushed in soft patches with a slightly thinned paint, then a brown wash over the whole hull and a light dry-brush on the edges. Decals or painted markings come last, under a matte varnish.
Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.























