In: Models

    Spider-Man 3D print models

    (7)

    Sculptors love Spider-Man because the poses are the point: crouched on a ledge, mid-swing, upside down. The fan-made 3D print models here include Miles Morales, Miguel O'Hara, a dark miniature version, a keychain and several classic suits, all independent sculpts; the character belongs to Marvel.

    Dynamic poses are also the printing challenge. A figure balanced on one hand or hanging from a web line needs supports placed where they will not scar the web pattern of the suit. Resin is the right process: the web lines are too fine for filament.

    Print miniatures at their native 32 mm for gaming, and figures at 12 to 20 cm for display, hollowed above 10 cm. Venom, Carnage and the rest of the rogues' gallery are in the Marvel theme.

    Printed in red resin with a blue painted suit, a 15 cm crouching Spider-Man takes an afternoon from slicing to varnish, and is a good first character print.

    7 models

    Spider man - 3D printable Heroes & Villains
    Spider man
    ‌
    ‌
    Spiderman Dark Miniature - 3D printable Heroes & Villains
    Spiderman Dark Miniature
    ‌
    ‌
    DOC OCK VS Iron SPIDERMANv - 3D printable Heroes & Villains
    DOC OCK VS Iron SPIDERMANv
    ‌
    ‌
    Spiderman - 3D printable Heroes & Villains
    Spiderman
    ‌
    ‌
    Spiderman Miles Morales Miniatures - 3D printable Heroes & Villains
    Spiderman Miles Morales Miniatures
    ‌
    ‌
    Spiderman Keychain - 3D printable Props
    Spiderman Keychain
    ‌
    ‌
    Spiderman Miguel Ohara - 3D printable Heroes & Villains
    Spiderman Miguel Ohara
    ‌
    ‌

    Frequently asked questions

    Keep the creator's supports where they exist, and if you add your own, put them on the underside of limbs and the back of the figure. Use light supports with small tips in Lychee Slicer and remove them before curing, when the resin is still slightly soft.

    A bust or a standing pose. Keychains and the crouched classic suit print in one piece with few overhangs. Save the swinging and wall-crawling poses for after you are comfortable with manual supports.

    Base coat in red, then a black wash that settles into the sculpted web lines, then a light drybrush of red on the raised areas. The sculpt does the lining for you; a brush-painted web is only needed on smooth suits.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.