In: Models

    Lord of the Rings 3D print models

    (4)

    Middle-earth in resin: Samwise, Smaug, the Balrog and a Hobbit diorama are among the Tolkien-inspired 3D print models published here. Independent fan art; the characters and world belong to the Tolkien Estate and its licensees.

    The theme spans tabletop miniatures for fantasy skirmish games and large display pieces, with Smaug and the Balrog as natural candidates for a 20 cm hollowed print. The rest of the fantasy shelf, dwarves, elves and orcs, fills out the armies.

    Scales vary by creator; compare the stated height on a model page with a figure you own before building an army.

    4 models

    Balrog - 3D printable Fantasy
    Balrog
    ‌
    ‌
    Smaug - the Hobbit - Lord of the Rings - 3D printable Creatures
    Smaug - the Hobbit - Lord of the Rings
    ‌
    ‌
    Diorama Hobbit - 3D printable Fantasy
    Diorama Hobbit
    ‌
    ‌
    Samwise Gamgee - Lord of the Rings - 3D printable Fantasy
    Samwise Gamgee - Lord of the Rings
    ‌
    ‌

    Frequently asked questions

    Most are sculpted at 28 to 32 mm and sit comfortably next to official figures, but scales vary by creator. Compare the height on the model page and adjust by a few percent in Lychee Slicer.

    Keep the creator's supports under the membranes, hollow the body and print at 0.05 mm. Large wings are often separate parts that pin to the body after curing.

    Print in red or orange translucent resin, paint the body in black with the flames left clear, and add yellow at the flame tips. An LED under the base lights it from within.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.