In: Models

    Lamps & lights 3D print models

    (10)

    Lamps are where 3D printing meets the living room: a pumpkin lamp, a lighthouse, a Coraline diorama lamp, a Calcifer fireplace, lantern props for dioramas and a few character lamps, most designed to take an LED tea light or a USB LED strip.

    Lamp shades and diffusers print best in white or translucent filament on an FDM printer, where a 0.8 to 1.2 mm wall lets light through evenly; vase mode produces seamless shades. Figurative lamps such as the pumpkin or Calcifer are often resin prints in translucent resin with a cavity for the LED. In both cases, keep heat sources low: LEDs only, never incandescent bulbs, as PLA softens above 60 °C and resin yellows.

    The model page lists the LED size the creator designed for. Lit dioramas also appear in book nooks, and the seasonal pumpkin lamps in Halloween.

    A diffuser wall between 0.8 and 1.2 mm gives an even glow; thicker blocks the light, thinner shows the layer pattern.

    10 models

    Cute Calcifer Fireplace Diorama Lamp - 3D printable Anime & Manga
    Cute Calcifer Fireplace Diorama Lamp
    ‌
    ‌
    Rowboats - Lantern - Paddle - 3D printable Miniatures & Tabletop
    Rowboats - Lantern - Paddle
    ‌
    ‌
    Jack-O'-Lantern Revenant - 3D printable Creatures
    Jack-O'-Lantern Revenant
    ‌
    ‌
    Light House - 3D printable Miniatures & Tabletop
    Light House
    ‌
    ‌
    Little Axolotl with Lamp - 3D printable Characters
    Little Axolotl with Lamp
    ‌
    ‌
    Coraline Lamp Diorama - 3D printable Anime & Manga
    Coraline Lamp Diorama
    ‌
    ‌
    Sinestro - Green Lantern - 3D printable Anime & Manga
    Sinestro - Green Lantern
    ‌
    ‌
    Lamp Master - Clair Obscur - Expedition 33 - 3D printable Characters
    Lamp Master - Clair Obscur - Expedition 33
    ‌
    ‌
    Jack-O'-Lantern Mimic + Pumpkin - 3D printable Creatures
    Jack-O'-Lantern Mimic + Pumpkin
    ‌
    ‌
    GYROID PUMPKIN LAMP - 3D printable Vases
    GYROID PUMPKIN LAMP
    ‌
    ‌

    Frequently asked questions

    LED tea lights, USB LED strips or low-power LED bulbs. They stay cool. Incandescent and halogen bulbs heat PLA past its softening point and discolour resin.

    Print in white or natural translucent filament with a wall of 0.8 to 1.2 mm, or in translucent resin with a 1.5 mm wall. Thicker walls block light; thinner ones show the layer pattern, which can be a feature.

    Most designs include a channel in the base; check the model page for the cable diameter. If not, drill a 6 mm hole at the back after printing, which resin and PLA both take cleanly with a sharp bit.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.