In: Models

    Ducks 3D print models

    (4)

    From a straightforward rubber-duck style to a Psyduck in a Christmas hat and a duck in armour: a small theme with a loyal following. Round bodies and flat feet make ducks one of the easiest animals to 3D print in resin or filament.

    Print at 5 to 8 cm with the feet on the plate and minimal supports under the beak; yellow resin is a one-step finish. A plate of a dozen small ducks prints in under two hours. More birds are in owls and chickens.

    4 models

    Psyduck - 3D printable Anime & Manga
    Psyduck
    ‌
    ‌
    Psyduck Christmas - 3D printable Anime & Manga
    Psyduck Christmas
    ‌
    ‌
    Duck Fighter - 3D printable Characters
    Duck Fighter
    ‌
    ‌
    GYROID DUCK - 3D printable Creatures
    GYROID DUCK
    ‌
    ‌

    Frequently asked questions

    Any stylised duck with a flat bottom, printed upright in PLA at 0.12 mm with a small support under the beak.

    Only if the model is designed hollow and sealed; most resin prints absorb water over time. Print in PLA or PETG and seal the seam for bath use.

    Yellow resin or a yellow base, an orange beak and feet, a black dot for each eye and a white highlight. No wash: the flat colours are the style.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.