In: Models

    Coasters 3D print models

    (3)

    A one-hour FDM print with no supports: a snowflake, a spider web, a bee, a sunflower. Flat 3D print designs that print face up in PLA or PETG and make a quick set of gifts.

    Check the diameter, usually 9 to 10 cm, and print a set of four on one plate. A sunflower or snowflake coaster in two colours is an easy first project on a multi-colour printer. The matching tableware is in mugs and cookie cutters; the bee and web designs also appear in insects and Halloween.

    3 models

    Sunflower coaster - 3D printable Home Essentials & Utilities
    Sunflower coaster
    ‌
    ‌
    Spider web coaster - 3D printable Home Decoration
    Spider web coaster
    ‌
    ‌
    Snowflake coaster - 3D printable Home Decoration
    Snowflake coaster
    ‌
    ‌

    Frequently asked questions

    PETG resists hot mugs and water better than PLA, which can soften under a very hot cup. Print at 0.2 mm with a few extra top layers.

    Yes for decorative ones, with a sealant on top; resin scratches and can yellow under hot drinks, so filament is more practical for daily use.

    Pause the print at the layer where the pattern starts and swap filament; most slicers have a pause-at-height option. The pattern layers print in the second colour.

    Models in the Lychee Library open directly in Lychee Slicer, with the supports and settings prepared by the creator. Whether the file can also be exported depends on the licence each creator sets, shown on the model page.