Lychee Slicer 7.6.5

This release brings a significant update to Anycubic printer settings, unlocking dual wait-time controls for bottom and normal layers, along with fixes to Adaptive Base support generation and layer count accuracy on export.

New 🎉

Updated Anycubic Printer Settings: Dual Wait Times

Anycubic has rolled out a major firmware update for their printers, and Lychee Slicer now fully supports it. You can now configure two separate wait times: one for the bottom layers and one for the normal layers on their latest printers

This is a significant improvement for print quality and reliability: having independent wait-time controls lets you fine-tune curing pauses at each stage of the print, reducing failures and improving adhesion where it matters most. These updated settings are available immediately in the resin profiles.

Fixed 🐞

Adaptive Base Support Generation Issue

Fixed an issue with Adaptive Base where support generation could produce incorrect results. Adaptive Base now behaves as expected across all supported configurations.

Off-Plate Objects Included in Layer Count on Export

Fixed a bug where objects positioned outside the build plate were still being counted in the total layer calculation during export. Layer counts now only reflect objects that are actually on the plate, giving you accurate slice information before printing.